Saniflo 010 Sanishower Drain Pump

Saniflo 010 Sanishower Water Pump

• The SaniShower discharges the waste through a 0.75-inch or 1-inch rigid pipe.
• A non-return valve is included on the discharge fitting assembly provided with the system.
• Has been designed to be vented through a 1-1/4-in or 1-1/2-in pipe.
• Vent output is located on the side of the pump.
• The side of the case has a knockout which along with the rubber adapter provided is used to connect to the vent pipe.
• Discharges gray water from a shower or sink.
• The gray water will drain into the system via the 1-1/2-inch side inlet (with built-in check valve) located on the side of the enclosure.

The Sanishower drain pump from Saniflo is used to pump gray water away from a variety of fixtures in residential applications. Easy to install and small enough to fit underneath a shower base, it is ideal for medium-duty applications.When the water enters the Sanishower, it activates a micro switch in the pressure chamber, which in turn starts the motor. A spindle/shaft drives the impeller and therefore the moving parts are kept to an absolute minimum. Water enters the chamber and is pumped away into the sanitary sewer. The unit pumps wastewater upward 12 feet and/or 100 feet horizontally (with gravity fall). Once the water level in the container goes back down, the unit deactivates until water enters again. A normal operating cycle for the Sanishower can be as short as 2 – 10 seconds, making power consumption minimal. All plumbing codes require connection to a vent system. Please note that the vent system should be a 2-way air vent. It is also highly rmended for the drain pump to be connected to a Ground Fault Interrupter (GFI) circuit.Pump out wastewater with ease with the Sanishower Residential Drain Pump from Saniflo.